Rothenberger Hand Roll Groover 1 - 12 Manuel d'utilisateur télécharger pdf (Page 13)

13 ESPAÑOL13 ENGLISH

Specifications

Capacity depending on rollers • 1” steel and stainless steel tube, SCHL 10 and 40

• 1 1/4” - 1 1/2” steel and stainless steel tube, SCHL 10 and 40

• 2” - 6” steel and stainless steel tube, SCHL 10 and 2” - 3 1/2 “ SCHL 40

• 4” - 6” steel and stainless steel tube, SCHL 40

• 8” - 12” steel and stainless steel tube, SCHL 10

Operation 1/2 inch wrench

Depth regulated by Gauges

Weight 12,5 Kg

The use of rollers on carbon steel and stainless steel may contaminate the stainless steel. This could cause ferrous

contamination and early tube failure. To avoid ferrous contamination, specific sets of rollers should be used

exclusively for stainless steel tubes.

Standard unit

The machine is equipped with a set of grooving rollers for 2 to 6 inch diameter type 10 tubes and 2 to 31/2 inch

diameter type 40 tubes, as well as a 1/2 inch manual wrench.

Main components

1. Regulating nut 2. Regulating locknut

3. Depth gauge 4. Guide screw

5. Roller slide 6. Roller shaft

7. Upper roller 8. Lathe screw

9. Transmission shaft

1. Specifications

DESCRIPTION, MAIN COMPONENTS, SPECIFICATIONS

Description

• This machine makes standard grooves on installed tubes (steel, stainless steel, PVC and aluminium from 1 to 12

inches in diameter).

The 1/2 inch wrench rotates a guide screw, which inserts a grooving roller inside the tube, and rotates the

grooving machine around the tube.

Figure 1

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 59 60

Pas de commentaire

Rothenberger Hand Roll Groover 1 - 12 Manuel d'utilisateur Page 13